StudentShare
Contact Us
Sign In / Sign Up for FREE
Search
Go to advanced search...
Free

Computational recruits - Lab Report Example

Cite this document
Summary
In this lab, the major objective was to simulate a RC circuit that could allow us to measure the current and voltage across the resistor and capacitor. Meeting the above objective provided a platform for exploring how charge on capacitor changes with time when different…
Download full paper File format: .doc, available for editing
GRAB THE BEST PAPER96.6% of users find it useful
Computational recruits lab
Read Text Preview

Extract of sample "Computational recruits"

Computational RC circuit Lab Introduction In this lab, the major objective was to simulate a RC circuit that could allow us to measure the current and voltage across the resistor and capacitor. Meeting the above objective provided a platform for exploring how charge on capacitor changes with time when different parameters were varied. Apart from a graph of charge on capacitor against time, another one for current against time was also plotted to current is affected by change on charge on capacitor.

This could the give an immediate overview about the activities of a capacitor in a circuit. Parameters that were changed to meet the objective of this study includes charge across, capacitance and resistance. ConclusionBoth simulation and laboratory procedures produced results consistent with expectations with empirical confirmation of the theory of the electrical behavior of RC networks as developed in the experiment. Further, the correctness of the development is confirmed considering that it agrees with the preceding experiment even though there were slight deviations.

The results thereby were successfully used to establish how change in resistance, capacitance, and charge affected the charge of the capacitor over time. When the charge was increased to 20, the charge of the capacitor slowly discharged over the course of the simulation, but converged on a value around 16 rather than descending all the way to 0. When capacitance was changed to 20, the charge of the capacitor very lowly descended until it actually attained a negative charge. When the resistance was increased to 30, the charge of the capacitor dropped to below 0 very quickly.

Further, the simulation also showed that the relationship between current and capacitor is such that when capacitor is fully charged the flow of any electrons is blocked thereby no change is observed in current at that point. The possible sources of error for the deviations can be attributed to experimental error especially for the simple mistakes in positioning the oscilloscope cursor. Other possible source is deviations observed in input-offset voltage and the input-bias current.

Read More
Tags
Cite this document
  • APA
  • MLA
  • CHICAGO
(“Computational recruits lab Report Example | Topics and Well Written Essays - 250 words”, n.d.)
Retrieved from https://studentshare.org/physics/1687720-computational-recruits-lab
(Computational Recruits Lab Report Example | Topics and Well Written Essays - 250 Words)
https://studentshare.org/physics/1687720-computational-recruits-lab.
“Computational Recruits Lab Report Example | Topics and Well Written Essays - 250 Words”, n.d. https://studentshare.org/physics/1687720-computational-recruits-lab.
  • Cited: 0 times

CHECK THESE SAMPLES OF Computational recruits lab

Lab Assignments for remote sensing

The resultant algorithms also ease implementation especially when a 3-diamentional color value needs to be textured. It is used when the user needs to further manipulate the… They also enhance reconstructions of branch situations when multiple corresponding regions are sliced from serial cross sections (Bannore 27). Bilinear interpolation, because faults and road are one dimensional Questions Why would most scientists use the nearest neighbor interpolation for rectification of images?...
1 Pages (250 words) Lab Report

Task about a Car

You are traveling in a car going at a constant speed of 100 km/hr down a long, straight highway.... You pass another car going in the same direction which is traveling at a constant speed of 80 km/hr.... As measured from your car's reference frame this other car is traveling at… What the acceleration of your car is as measured from the other car's reference frame?...
2 Pages (500 words) Lab Report

Estimating the Damping in a Single Degree of Freedom System

Any type of system mechanical system can be caused to vibrate by applying external forces due to… In this lab experiment, we are required to determine the damping ratio ζ, in a simple mechanical system that consists of a weight that is attached to a beam on one end.... A mechanical system can be said to be in vibratory motion if pats of its components are undergoing what is referred to as periodic oscillation about the central equilibrium position....
5 Pages (1250 words) Lab Report

Computational Exercise 3 : Cyclotron motion

Introduction:(6pts)In this lab, we were simulating the motion of the charged particle.... computational Exercise 3 Worksheet: Cyclotron motion What is cyclotron motion?... Write down the equation for the magnitude of the centripetal force.... Set these two equations equal to each other, and solve for the radius....
1 Pages (250 words) Lab Report

Analysis of Chimeric Proteins by Fluorescence Microscopy and Western Blotting

nbsp; A piece of nitrocellulose membrane labeled the lab group name (when wet) was submerged in nanopore water and left until it was ready for use.... This work called "Analysis of Chimeric Proteins by Fluorescence Microscopy and Western Blotting" describes western blotting, processing of the blot, development of the membrane....
10 Pages (2500 words) Lab Report

Implementation of Computational Fluids Dynamics

"Implementation of computational Fluids Dynamics" paper carries out computerized fluid dynamics of s-shaped pipe in terms of its behavior when pressure, temperature, velocity, Mach number, and change of density and velocity used.... The analysis will be a 3D dynamics simulation.... hellip; The pressure defect at the back of the cylinder tends to “fill up” with blowing, leading to lower transverse static pressure gradients in the near wake....
7 Pages (1750 words) Lab Report

Implementation of Computational Fluid Dynamics

… The paper “Determining the Behavior of Two Different Fluids Flowing through Pipes of Different Lengths”  is an opposite version of a lab report on physics.... The paper “Determining the Behavior of Two Different Fluids Flowing through Pipes of Different Lengths”  is an opposite version of a lab report on physics....
13 Pages (3250 words) Lab Report

Implementation of Computational Fluids Dynamics

rdquo;  is a comprehensive example of a lab report on physics.... rdquo;  is a comprehensive example of a lab report on physics.... … The paper “Why Are computational Requirements for the Flow Representation So Considerable?... The paper “Why Are computational Requirements for the Flow Representation So Considerable?...
5 Pages (1250 words) Lab Report
sponsored ads
We use cookies to create the best experience for you. Keep on browsing if you are OK with that, or find out how to manage cookies.
Contact Us